PDA

View Full Version : need help with installing c-33 grip on 2006 saber



MRHAPPY
05-09-2007, 08:51 PM
hi ,just recieved a c-33(thermal elite grip for my martin saber, came with two screws? looks like i only need one? two leather pieces, can't tell where or how they go onto the grip? under the wooden grips? help??

Elk4me
05-09-2007, 09:05 PM
Take the leather pices and dry fit them to the riser find out which one goes where. then they fold around the front of the grip area and the back of the grip area, the press in the side plates and use what ever screw ya need to tighten the grips up! I put the small piece in the back of the riser and the longer piece on the front! If ya have a problem call me 406-297-0233. Here is mine on my Pantera:

http://i18.photobucket.com/albums/b116/Elk4me/07MartinPantea.jpg

MRHAPPY
05-09-2007, 09:14 PM
yea, i finally figured it out, i put small one on back also, but i had a limbsaver on the front already so just left the other leather piece off, did you put locktite or anything on the screw? didnt seem like i could tighten screw very tight without stripping it maybe, thanks for your help!

MRHAPPY
05-10-2007, 07:18 PM
wow , i like this grip alot better than the thermal grip that came on the saber, thanks alot , should i ad some type of glue to the screws in thegrip or the inside of the grip itself ?

bfisher
05-10-2007, 08:30 PM
No glue or loc-tite needed. Things aren't going to fall apart. Oh, good choice on the grip. It's my favorite on my Pantera, too. And on my P3 target bow.