View Full Version : Martin Lynx Cam question? Pic posted, Anyone know cams/draw/lbs
06-16-2007, 03:47 PM
Martin Lynx Cam question? Pic posted, Anyone know cams/draw/lbs
Reply with any info/
06-16-2007, 07:41 PM
Looks like it has flite wheels on it if it has 3 slots in the wheel measure the wheel they look like 2 inch flite wheels in the pic that would make it about 29 inch draw.Post a wheel measurment an I can give you a exact draw........:)
06-17-2007, 09:00 AM
Picture of cam up close, 1 3/4" diameter cam ANY INFO?
Draw seems to be close to 28" right now, maybe 29"
Would like to know letoff, draw lengths for these cams, draw weights for this bow with these cams.
06-17-2007, 11:38 AM
The wheel is in the long draw slot in your pic an you say it feels about like its 28 inch draw on the spec sheet they used the 1 3/4 flite wheel to get 27 an 28 inch draw length in the center slot of the wheel.To know which one you have you have to measure the draw length or the pigtail that comes out of the wheel measure from the set screw in the wheel to where the string attaches to the teardrop on the cable if it measures 7 3/4 inches the draw is 27 28 29....28 is the center slot in the wheel the other two slots let you shorten or lengthen the draw a inch.If it measures 7 1/2 the draw would be 26 27 28...27 being the center slot with the same adjustments above.the let off is 65% though if you measure it it was closer to 60% on a scale
Powered by vBulletin® Version 4.1.12 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.