PDA

View Full Version : How Do I Change My Draw Length



coolsam402
11-13-2011, 10:59 AM
4930

this is my issue i cant get the screw out its like under the limb

gravedigger
11-13-2011, 11:14 AM
befor cam is rotated
http://images.imagelinky.com/1321218332.JPG (http://images.imagelinky.com/1321218332.JPG)
hand position befor rotating cam
http://images.imagelinky.com/1321218379.JPG (http://images.imagelinky.com/1321218379.JPG)
cam after rotation and now there is plenty of room to get the allen screw out wile your holding the cable
http://images.imagelinky.com/1321218465.JPG (http://images.imagelinky.com/1321218465.JPG)
hand position wile holding cable back to get allen screw out.the cabel to hold back is the one closet to the riser.it will give you the slight rotation needed to remove the screw.
http://images.imagelinky.com/1321218523.JPG (http://images.imagelinky.com/1321218523.JPG)

coolsam402
11-13-2011, 11:22 AM
so after i get the screwout do i have to keep holding it or no can i let go

gravedigger
11-13-2011, 11:24 AM
so after i get the screwout do i have to keep holding it or no can i let go

slowly let it go.and put you draw mod inyou can get the top screw back in befor having to pull back the cabel again just to make sure it is held in good.

gravedigger
11-13-2011, 11:26 AM
or better yet do as i did in the pic but just take the problem screw out then let it down.then you can take the ez screw out.....replace with the mod you want.....put the top screwn in.......then pull the cable to get the problem screw in place...........does that help

coolsam402
11-13-2011, 11:30 AM
ok hey thanks so much this def needs to be stuck on these forms best info i have ever receaved

droppixel
11-14-2011, 11:35 AM
Grow longer arms and then adjust your bow :p

gravedigger
11-14-2011, 01:42 PM
Grow longer arms and then adjust your bow :p

i have ben trying but that growth stuff out of the back of comics aint working:p:p:p

bowgramp59
11-14-2011, 01:42 PM
the way i did it was loosen the limb bolts several rounds then you can turn the cam enough to get the screw out and in without any trouble, then tighten the bolts back down!