View Full Version : Martin Threshold Draw Module Blocke

12-26-2011, 07:26 PM
Hello all!

I recently acquired a new Martin Threshold (70# model) for Christmas, and it came with a 30" draw. I want to adjust this to a 28" draw, and I have the appropriate modules to do so. However, when I went to unscrew the screw on the back of the cam to release only the module, the back screw was blocked by the limb. Any ideas as to how to get access to this screw so I can replace the module. The other screw came out just fine.

Thank you

12-27-2011, 05:20 AM
welcomr to the forum.im a bit suprised no one chimed in,so here is a link with pics.it really is ez and you will have no trouble swaping it out.

Arrow Splitter
12-27-2011, 05:22 AM
Welcome to the forum.
To change the module you can also use a bowpress in addition to the ways stated in the link gravedigger gave.


12-27-2011, 05:32 AM
Wrap a zip tie around string and cable, pull tight enought to rotate the screw into a postion where you can get your allen wrench to the screw.

12-27-2011, 06:25 AM
Thank yall so much! That did the trick!