PDA

View Full Version : 2011 pantera



slickhead1
02-17-2012, 03:30 AM
Is the 2011 Pantera back drillled for a string stop.. If so will it accept a bow rattler 6 1/2 to 8" adjustment

archerx7
02-17-2012, 03:38 AM
The 2010 and 2011 Panteras shared the same riser, so it should come from the factory with a 3/8" hole drilled in the rear of the riser for a low mount sts. If the BowRattler comes with a 3/8" mounting rod, it should fit.

MLN1963
02-17-2012, 05:27 AM
The 2010 and 2011 Panteras shared the same riser, so it should come from the factory with a 3/8" hole drilled in the rear of the riser for a low mount sts. If the BowRattler comes with a 3/8" mounting rod, it should fit.

Jim

How did they mount the TRG on the 2011s since the 2010 had the CCS?

archerx7
02-17-2012, 05:33 AM
Jim

How did they mount the TRG on the 2011s since the 2010 had the CCS?

They would have used the cable rod bracket that mounts on the sight side of the bow in place of the CCS.

MLN1963
02-17-2012, 05:41 AM
So a 2011 TRG equipped Pantera can easily become a CCS equipped Pantera? What would it cost to make the conversion?

elkslayer4x5
02-17-2012, 06:05 AM
According to the 2012 Martin store, the Martin Cable Containment System is $28.25. Here's the webpage.
http://www.shopatron.com/products/productdetail/CCS+Martin+Cable+Containment+System/part_number=CG3/189.0.1.1.0.0.0.0.0?

archerx7
02-17-2012, 06:10 AM
So a 2011 TRG equipped Pantera can easily become a CCS equipped Pantera? What would it cost to make the conversion?

I am going strictly by the photos of the 2011's.......didn't see any 1st hand. If the bow has the rectangular cutout on the sight side of the riser for the rod bracket/ccs, then yes.......it could easily be converted to either the rod and slide or the ccs, but it has to have the cutout in order to do so. As far as the cost, you would need the ccs itself which is part#CG3 and you would need to get the string/cable served where it runs through the rollers.