PDA

View Full Version : Brace Height



aldenjj
02-28-2012, 12:22 PM
I was checking some of the specs. on my new Exile Bow, before I bring it to a Martin dealer tomorrow to be fitted with sight, rest etc.
My question is this, I measured the ATA length and it is right on the mark (30.25 inches)
I measured the Brace Height, and it is (7 inches, not 7.25, which is what the spec says the bow is. What if anything does that mean? The bow is the 60# version, and it is pretty much set at 60.

wscywabbit
02-28-2012, 12:27 PM
I wouldn't worry about it too much. You could take the strings off and measure them, but it's kind of a PIA; you'd need a press to make it easier and a way to stretch the strings. If you're close and its shooting well, you're probably good.

aldenjj
02-28-2012, 12:39 PM
I was thinking that mabe the string will stretch a little. The bow is brand new and has never been shot. Once I get it set up and shoot it a little I will recheck. Thanks for the input