PDA

View Full Version : ShadowCat Nitro 2.0 Modules



Atavio
03-30-2012, 12:33 AM
Advice Please: have tried to decrease my draw length to 30" (currently @ 31") by changing the screw positions on the Nitro 2.0 modules,, but after lining up the screws in the new locations on the modules, the screws will NOT screw into the new locations; get about 1/2 turn but cannot turn more for fear of stripping the threads n the screws or the modules. Feels like the placement is off by about 0.5mm. Any advice as to what I could be doing wrong?
-Atavio-

Phantonza
03-30-2012, 12:49 AM
Can you screw them if the modules are not placed on the cam?

Atavio
03-30-2012, 01:06 AM
Good question..
I will check that in 4.5 hours when I return home from work!
-Atavio-

bfisher
03-30-2012, 04:08 PM
If that doesn't work then try running a tap through the holes on the cam to clean up the threads. I'm not certain but I think they are 6x32.

Atavio
04-20-2012, 08:30 AM
Took forever, but I'm finally getting back. No, the screws will not fit either way. I called Martin Archery, and they also suggested tapping th ethreads. Well I'm not going to get into all of that, will just make do.

Thanks!

Atavio

bfisher
04-20-2012, 11:05 AM
Any decent archery shop should be able to use a tap to chase theose holes and it should only take about 5 minutes to do so.