View Full Version : New Bengal, can I change plastic mods myself?
12-29-2007, 01:45 PM
The book that came with my new bengal explains quite a bit, but not how to change plastic modules. Can I change them myself, if so how do they install and do you remove existing ones? Also, which one would I use for 29" Draw?
12-29-2007, 02:55 PM
There are two coutersunk set-screws holding the module to the cam. Remove them with the appropriate size allen head wrench. Sometimes one of the screws is hidden behind the limb fork. You can just squeeze the cable to get it out where you can get the wrench on it. It depends on how the cam is positioned, when I do this I sometimes just wrap a zip-tie around the cable and riser to hold it in place while making the swap.
To install the new module just do the procedure in reverse. Then, if you use a zip-tie, hold the cable and cut the zip-tie with a scissor.
If you want to make the job a little easier you can back some weight off the limb bolts. Up to you.
Powered by vBulletin® Version 4.2.2 Copyright © 2014 vBulletin Solutions, Inc. All rights reserved.