PDA

View Full Version : Nitro cam rubbing against limb and QAD Ultra Rest problems - Please help!!



deserthuntr
07-15-2012, 03:31 AM
Hi Everyone. Have been shooting my new Onza 3 and am really enjoying it. But I have a few problems. Yesterday I noticed the top cam rubbing against the limb! How can I fix this? I am in Africa and don't have time to send my bow to the dealer as I have a hunt in 2 weeks time! I have a press and a lot of tools, how do I fix this?

I also have a lot of fletch contact on my QAD ultra rest, anyone have any ideas on how to get better fletch clearance please? Can I set the spring tension? Or should I get a Trophy Taker? My nocking point is about an 1/8" high. Any help will be appreciated! Thanks guys.

Speedykills
07-15-2012, 06:45 AM
Could be excessive cam lean or weak limbs,you might want to double check specs make sure everything is right.
As far as qad rest goes i just installed one on bengal no problems.Might want to check tension,usually if lines are even you good to go.I would shoot through paper to see if you off any.Are you getting contact on one vane or both!I take it youre shooting cock vane up!If your getting contact on one vane move rest in that direction to see if it clears.

deserthuntr
07-15-2012, 01:23 PM
Could be excessive cam lean or weak limbs,you might want to double check specs make sure everything is right.
As far as qad rest goes i just installed one on bengal no problems.Might want to check tension,usually if lines are even you good to go.I would shoot through paper to see if you off any.Are you getting contact on one vane or both!I take it youre shooting cock vane up!If your getting contact on one vane move rest in that direction to see if it clears.

Yes I shoot cock vane up, is that right? I get contact on both the other fletches!

Speedykills
07-15-2012, 05:39 PM
To me it sounds like your timing isnt right and or your nock point height needs adjusting.I say paper tune it to see whats it's doing and readjust the drop cord.If your using the little football it might have slipped...I use the football but it is nice and tight.....Also might have some string and cable stretch going on.
Yes cock vane up is right.

skidge
07-21-2012, 11:43 AM
I have had same problem with my 2011 onza and 2012 cougarfc. You need new cams, the bushing are not perfectly square. talk to martin cs, tell them situation, they can mail u cams.