PDA

View Full Version : Retrofitting my Rytera with nitrous



bowhunter 1968
01-05-2008, 05:38 PM
I am putting some c-based nitrous cams on my bullet-x. I was wondering does martin still have mini mods for the nitrous cams? I have tried calling Martin 3 times this week and the receptionist said the tech center was busy and to call back later. Also would they have the thin washers that go between the cam and the limb. By the way she was super nice.

cowboyarcher1
01-05-2008, 10:51 PM
I am putting some c-based nitrous cams on my bullet-x. I was wondering does martin still have mini mods for the nitrous cams? I have tried calling Martin 3 times this week and the receptionist said the tech center was busy and to call back later. Also would they have the thin washers that go between the cam and the limb. By the way she was super nice.

She usually is!!

Anyhow, Joel is very busy I think. Leave a message or you may never get him!

They should have everything you need still.

Cowboy

J-Daddy
01-06-2008, 01:26 AM
I just got a new set of nitrous cams & mini mods in today from Martin "Thanks PUG"...So yeah they still have them instock.