View Full Version : Toxonix Target Sight

11-05-2012, 03:40 PM
I've got an older Toxonics Model 5000 with a 9 inch extenion bar, complete with a 1.5" HHA modified scope. the scope has an Extreme Fire up pin with 5 feet of .10 fiber optic. Have over $150 invested ( got it used ) in the sight and scope, I'll let it go for $100, you pay the shipping. It is NOT assembled in this photo.

http://images.imagelinky.com/1352153616.JPG (http://images.imagelinky.com/1352153616.JPG)

In order to get it into the smallest USPS Flat Rate Priority box, I had to disassemble the extention bar, the following photos show how it re-assembles, first attach the T piece to the extention, with the cap screws that are taped into place in the T piece.

http://images.imagelinky.com/1352153078.JPG (http://images.imagelinky.com/1352153078.JPG)

Next fasten the extentention T to the back side of the Elevation block. Shown here with out the extention attached.

http://images.imagelinky.com/1352153259.JPG (http://images.imagelinky.com/1352153259.JPG)

The scope body mounts with the knurled knob towards the Toxonics label side onto the sectioned brass plate B. The large silver knob A on the front of the sight block locks the sight in place, loosen a bit to move with top or bottom silver knurled knobs, loosen several turns and you can make large movements.

11-05-2012, 03:53 PM
Sold to screamingbuick. Thanks Bob, I'll be sending out 1st thing in the morning by USPS Flat Rate Priority Mail.