PDA

View Full Version : 2013 arty era Nemesis Hybrix 3.0



Harley D
02-08-2014, 11:53 PM
I am thinking about purchasing one of these but I'm confused about the draw length. Some say the Hybrix 3.0 cam goes from 28-31 inches and some say 27-30 inches. Are there different modules for this cam to obtain both of those draw length ranges? Thanks in advance!

underwood
02-09-2014, 01:42 AM
I have 2 bows with the 3.0 cams. And both cams have adjustment mods that can be set for 26.5 - 30.5 DL. One bow is the nemesis 35 W/ nitro cam. The other bow is a Seeker 365 W/ hyper-x cam.

Harley D
02-09-2014, 10:12 AM
Appreciate the post. Still need the actual draw length range on a 2012 Rytera Nemesis with the 3.0 cam on it.

bfisher
02-09-2014, 03:14 PM
2012 Nemisis did not use the 3.0 cam. It was a Hyrbix 2.0 (large) and Hybrix 1.5 (small). For ease of explanation assume the 2.0 to be the new 3.0L and the 1.5 to be the 3.0S.
The Martin line used the same cams system, but they were named Nitro cams.

Each cam covers a range of 3". The 1.5/3.0S covers draw lengths from 26" to 29". The 2.0/3.0L covers from 27.5" to 30.5". As you can see there is an overlap between the two so within that range, say 27.5" to 29" you could use either cam. The module is the same for both cams, allowing 1/2" adjustments.

Hope this clears things up. This shown on page 21 of the 2014 catalog under the Nemisis Nitro column. Only difference is with the 3.0L that covers from 28"tto 31" due to the 1" longer a2a of this bow.

Harley D
02-12-2014, 12:51 PM
Appreciate it!

webbnate_45
02-12-2014, 06:53 PM
Are you looking at one of the bows listed by kmarcheryhut? If so yours is more than likely like mine and has the 3.0 cams, which as bfisher said was not a cam offered on the 2012 Nemisis. They kinda built them with different parts to get rid of some old stock. There are some other posts on here that cover a lot of these bows and common questions people had when they got them. If it is the Nemesis with Hybrix 3.0 cams like mine I highly recommend it, it shoots like a dream! (Actually, I recommend any Martin bow) Hope I was able to help somewhat and good luck!

Harley D
02-12-2014, 10:16 PM
Yes that is what I'm looking at. What does yours go down to on draw length?

Harley D
02-13-2014, 02:32 PM
Well, I pulled the trigger and bought one. Can't wait to receive it! Hope I can get the draw length down to about 27.5 inches.

wscywabbit
02-13-2014, 03:07 PM
Congrats! Should be a great bow ;)

webbnate_45
02-15-2014, 08:07 PM
Well I am not 100% positive on how far down it can go. I am a 28" draw and it is in hole 3 on the mod, so going down to 2 or 1 should get you there just fine. It is simple to adjust the draw length as well so no worries there. You made a great choice in bow and congrats on the purchase!