View Full Version : cable gaurd clearance
09-04-2008, 11:12 PM
I have noticed that my blazer vanes are touching the cables on my bullet x is there a measurement to move the cable gaurd rod over or do you just move it enough to keep the cables off the vanes. My bullet has the vipro cams. Any advice would be appreciated, Thank you.
09-05-2008, 04:46 AM
Just move it enough so they cleear
09-05-2008, 11:26 AM
Exactly. Adjust it, give yourself about 1/8" clearance and lock it down. The more you turn it the more side torque it'll cause. Keep it to a minimum.
Worse comes to worse, get rid of the Blazers. As you are finding out they can create some problems, too. That's why I went to a Duravane LP 400. 3/8" high instead of 9/16".
Powered by vBulletin® Version 4.2.2 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.