Wood replacement grip for '08 Firecat

[OregonHunter]

Is a replacement wood grip available to replace the factory rubber grip on the '08 Firecat (should be same as '09)?

[Montalaar]

It is possible. Maybe you should have a look at those aftermarket grip makers. Seem to do a great job!

[CrowMagnumMan]

It is possible. Maybe you should have a look at those aftermarket grip makers. Seem to do a great job!

Yep. Go with Bob Lambeth!

[bfisher]

If you like the grip as is except for the fact that it's rubber then Martin makes the Thermal Elite grip. It's virtually the same except uses wooden side plates and a self sticking leather pad on the front and back side of the riser. This is what I order on all my bows.

[OregonHunter]

Ok thanks for the tip.
There turns out to be 2 wooden grips, this one:
http://www.shopatron.com/product/part_number=C33/189.0.5881.0.0.0.0
and this one: http://www.shopatron.com/product/part_number=C39/189.0.5881.0.0.0.0

Any experience with the latter?

[bfisher]

Ok thanks for the tip.
There turns out to be 2 wooden grips, this one:
http://www.shopatron.com/product/part_number=C33/189.0.5881.0.0.0.0
and this one: http://www.shopatron.com/product/part_number=C39/189.0.5881.0.0.0.0

Any experience with the latter?

No sir, None at all.

[Montalaar]

The second one is on all of my bows.

I can only say: works fine.

I see no use for me in any leather strip around the grip as it does not feel good for me.

[davydtune]

http://www.archerytalk.com/vb/showthread.php?t=950128



:D

I'm sure he's do a set up for martins just PM him.