Optimum NOCK point? Martin Cheetah 2007.

[otiswinkerbean]

I have aquired an 07 Martin Cheetah and have installed the F7 module to obtain what I hoped to be a 30" draw length(?). I have seen video references to a flat / level nocking point all the way to 1/2" high with more than a few references to 1/8" high. I would appreciate your input as to preferred nocking point location. I have been happy enough at FLAT / LEVEL but wonder if I am missing out on some increase in accuracy?

My rest is a Golden Key Ultimate TM Hunter, the sight is a Cobra Boomslang 4-pin and my arrows are 30.5" Easton 2419 aluminums with 125 grain field points and 3.125" QuickSpin vanes. The 1st carbon arrows I acquired were being damaged by my carpet bale target so I went to these heavy weight alloys for back yard durability.

[hotrod26]

With the F7 mod you will only get 29" DL. I have a 07 Cheetah and that is all you can get for DL.

[otiswinkerbean]

I just checked the Martin 2007 spec chart and see that they have a 2007 M-Pro Cheetah with the F-7 module as a 30" draw length? Is this a marketing ploy, a mis-print or what? I settled on this bow primarily due to the desire for a 30" draw as my last bow was tagged at 29" and I felt that the longer draw length would better fit my long arms etc... I like the bow just as it is HOWEVER I see by the arrow overhang that it is not longer than my old PSE and might even be a tad shorter.

[hotrod26]

That has to be a misprint because the Cheetah has always been 29" with the F7. If you look at the 08 and 09 spec. charts you will see that it is 29".