PDA

View Full Version : Martin 04 Slayer



martin60
08-19-2009, 07:37 AM
Just installed a new custom made string and cables.
Bow shot great befor.
Timing is right one with the Nitrous C cams
28 1/2 draw at 64 lbs
Left handed
Carbon Express 350's 100 grain tip
.
Have installed string loop 1/16 above level.
Arrow is right on with the center shot.

Still having some problems getting the arrow to fly true.

Anyone have any experiance with nock height and center shot

cherryju1ce
08-20-2009, 02:41 PM
Just installed a new custom made string and cables.
Bow shot great befor.
Timing is right one with the Nitrous C cams
28 1/2 draw at 64 lbs
Left handed
Carbon Express 350's 100 grain tip
.
Have installed string loop 1/16 above level.
Arrow is right on with the center shot.

Still having some problems getting the arrow to fly true.

Anyone have any experiance with nock height and center shot



Paper tune, and go from there. When I install new strings, I make sure a few things are still correct. I check to make sure the tiller is even, the cams are in time, my center shot is down the dead center of the riser line, my arrow is bisecting the berger holes, and the nock point is 1/8" high. From there, I paper tune, and usually only very small adjustments are needed from there. It sounds like your arrows are spined just about dead nuts for that setup, so I don't think that's the problem. Good luck.