PDA

View Full Version : Cam washers..



Coop
08-24-2009, 07:05 AM
Does anybody know if the black plastic washers(inside spacers?), on the axles... are suppose to be the same width? I have the Sceptor 4 Elite, furious dual cams.

Coop

elkslayer4x5
08-24-2009, 10:07 AM
I have three Martin bows, each has the X-shoot-thru system, with long axles on the bottom. Each bow has differnt size spacers mixed on each axle. By mixed I mean that there are differnt size spacers togaher on each axle in order to take out any 'slop' ( no extra space ) Does that help?

Coop
08-24-2009, 10:36 AM
I'm just making sure that I have the right size(width) spacers on each side of my module & cam. My spacers look about 1/8" thick(both sides, top & bottom)... Since I have the dual cams more than likely, your spacers would be different( I'm guessing here), since you have the 'X' setup. I'm thinking again... that the spacers have to be right(width) in order to have the shooting string lined up with the riser?

Coop

Coop
08-24-2009, 10:41 AM
I have a left handed bow..


Coop

RogerSr
08-24-2009, 04:33 PM
coop,
all shoot thru systems have dual cams also.

scepterman30x
08-25-2009, 06:20 AM
Does anybody know if the black plastic washers(inside spacers?), on the axles... are suppose to be the same width? I have the Sceptor 4 Elite, furious dual cams.

Coop

Yes...the spacers on either side of the cam on the inside of the limb fork should be the same width.

Coop
08-26-2009, 05:50 AM
I appreciate the info..
Coop