help building 2 custom Scepter4's

[SandSquid]

I'm trying to rebuild some scpeter4's to get them perfect for my "new" draw weight and lenght. I would very much like the hunting bow to peak at 45#(minimum weight for deer in most states) to get maximum performance at that weight, I cannot go past 45#, Dr's Orders!

Draw lenght is 27.5 to 28" depending on fiingers or release shooting


Here is what I have to work with...

I have only 1 Nitrous B base Cam but several Nitrous A base Cams



The Chameleon riser is strictly for NFAA Indoor 5 spots shooting.

Elite 17" limbs
1L
2L
3H


The Camo Riser is for hunting flesh and foam and field archery and banging around in general.

14" Magnum 0M (camo)
14" Magnum 4M (Camo)
16" Straight 01L (Camo)
16" Straight 01H (Carbon)

[scepterman30x]

Heres what you need to get you as close to 45# for bothe setups. I assume you will be putting the B's on the Mag limbs and the A's on the Elite. If that is the case this is what you need.

B's on the 01 H mag limbs

2L's on the Elite limbs

Scott

[scepterman30x]

BTW you can achieve up to 28" on the S4 mag with the A cams however I'm not sure they make limbs that are deflected that low for your poundage. Even 1L's go to 65# or more with the A cam.

[SandSquid]

I assume you will be putting the B's on the Mag limbs and the A's on the Elite.

that was the plan.... Maximum scoot given my limitations on the outdoor bow, and take it easy on the newly installed bicep tendon when shooting 60 + arrows a day indoors.