View Full Version : Dyan Cam Modules
12-28-2009, 07:20 AM
Does anyone know if a bow press is required to change out the modules in the Dyna Cam
12-28-2009, 07:58 AM
These are "F" modules and no press is needed. You just remove the module screws and swap modules. However, you may run into a situation where one of the screws "hides" behind the limb fork. If so you can so one of a couple things. Just squeeze the cable toward the riser. This should rotate the cam enough to allow you to get at the "hidden" screw. If you can't holt the cable in this position you can either back off the weight about 3-5 turns and try again or squeeze the cable and wrap a zip-tie around the cable and riser to hold it in place. It's pretty straight forward.
When you're done just hold onto the cable and cut the zip-tie with a scissors.
Powered by vBulletin® Version 4.2.2 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.