View Full Version : vapor Trail limb driver
02-25-2010, 12:02 PM
Has anyone used the limb driver? Any thoughts?
I was thinking of putting one on my alien.
02-25-2010, 03:16 PM
I am just getting into sights and fall away rests after 30 years with bare bow and fingers, and at the recommendation of several forum moderators, tried a limbdriver on my bow . Have to say it was dead easy to set up and very impressive to use. From my very limited experience would definitely recommend it.
02-25-2010, 07:26 PM
I have had them on the last Six bows that I have,and I still have four with limbdrivers, every bow I have right now but my recuvers have them, they are the best rist I've used in the last fifty years, and I've used a lot of them!
02-26-2010, 12:28 PM
I have one on my Bengal and it is awsome! :D
02-28-2010, 10:43 AM
It is a arrow rest made by Vapor Trail archery, that uses a cord that goes to the top limb to bring the louncher arm up for the fall away like this,
I see sounds like a good thing to me if it works that would be more for a target bow right by the way looks like a very nice set up
02-28-2010, 02:25 PM
I use them on my hunting bows as well, as do a lot of other guys.
03-03-2010, 11:52 AM
anyone else have an opinion?
03-03-2010, 04:12 PM
You can add me to the ranks of those loving this rest. I've had this rest for a year and a half and haven't even considered replacing it. My bow is primarily for hunting but I do quite a bit of target shooting during the off season too. Like the others said, this is a VERY easy rest to setup and due to the activation line connecting to the upper limb the rest gets pulled down and out of the way very positively, yet remains up to stabilize the arrow flight for up to 70% percent of the arrow length before dropping down. I've shot Blazer vanes as well as FOBs through it and never had any contact issues.
03-03-2010, 08:05 PM
I have the LD on my Alien and it works awesome
Powered by vBulletin® Version 4.1.12 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.