PDA

View Full Version : Draw Stop



Lthrnck03
03-30-2010, 05:10 PM
Whats the proper allen wrench size to adjust the draw stop. Manual says that its 8/32. If I am not mistaken, isnt that the same as 1/4?

bfisher
03-30-2010, 06:39 PM
Whats the proper allen wrench size to adjust the draw stop. Manual says that its 8/32. If I am not mistaken, isnt that the same as 1/4?

Your math is good. 8/32 is indeed 1/4, but the drop stop bolt is not 1/4". It's smaller than that. I use one of the multi-allen wrench tools and can't remember just which one I used, but it's either 1/8" or 9/64". That being said, if the manual says 8/32 then it's just a misprint and I'll bet it's 8/64" which is 1/8".

I could go get my bow out of the back of the truck, but it's too cold and windy for me to trek out there in my bare feet in my pajamas.

Lthrnck03
03-31-2010, 05:58 PM
FYI......9/64 was the correct size. Thanks bfisher!!!