firecat question

[edjack]

i have 09 firecatbut with 2010 limbs and cat2 cams. what would be the ata and bh specs. thanks for any info

[bfisher]

Should be the same as for 2010 specs or close to it. I have a 2008 withe the same setup and I can honestly say I've never measured it. I don't really care what it measures. I set it up to shoot the way I like and let the specs fall where they may.

[Brem]

edjack,
BH should be 7" and ATA is closer to 32 1/2" than the specs that say 32 1/4".

[edjack]

thanks everyone

[tood s]

do you measure the ATA & BH with the limbs cranked all the way down? i wanna check my cables to see how much twisting i have to do to wrap the cams. so im guessing that i have to crank it down to check all this before i turn the limb bolts out to start wrapping.

[Coop]

Crank all the way..than measure.

Coop

[tood s]

thanks alot

[bb11]

Ao you meansure the ATA at the center of the cams while cranked?

[bfisher]

Ao you meansure the ATA at the center of the cams while cranked?

A2A is measured from center of axle to center of axle. If you are using a metal tape measure you can measure from the outside of one axle to the inside of the other. Either way you'll get the same measurement.

[bb11]

thanks bfisher!