View Full Version : Cam squeek on a Cheetah
04-30-2010, 06:44 PM
I think it is the bottom cam it squeeks when drawing to full draw, is there a way to lube it? or can I just spray wd40 on it?
04-30-2010, 07:04 PM
Don't get WD-40 anywhere even close to a bow. It may act as a lubricator, but also attracts and holds grit and dirt which ends up being abrasive over time. No oils!!!!!!
Try any type of silicon spray. Something you might check in the future is how tight the cam is. Could be that the spacing between the limb forks is just a hair on the snug side. The cam should rotate freely. If it's tight you can pull an axle part way out of the limb; enough to remove one of the spacers. Then take a small piece of fine grit sand paper, lay the spacer on it and rub it around to make the spacer a bit thinner. They're only plastic so don't get carried away.
05-01-2010, 03:56 PM
Powered by vBulletin® Version 4.1.12 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.