PDA

View Full Version : Looking for a sight



jasonrkba
05-25-2010, 08:13 AM
I need a new sight for my old Bobcat. After replacing the arrow rest I had to move my sight, now the top pin is so high and to the right I can barley see it. I have been looking at sights but my set up is an old design where the suppressor rod and sight share the same bracket and the newer style sights bolt right in where the bracket on mine is. Anyone have a suggestion? I have provided a picture for reference.

http://i290.photobucket.com/albums/ll254/jlbeck182/DSC00890.jpg

KStigall
05-25-2010, 01:22 PM
Make sure your nocking point isn't too low which would launch your arrow upward. The arrow should be level at rest from the berger hole (rest bolt hole) in the riser to the nock.

jasonrkba
05-25-2010, 09:22 PM
I used the one of these.

http://shop.eaglearchery.com/browse.cfm/4,9299.html?AFF=BASE

jonusb2
05-26-2010, 07:56 PM
On the one hand,it toronto asian escort (http://www.escortstorontodirectory.com) will make children lack independence and initiative,which is unfavourable to toronto escort (http://www.escortstorontodirectory.com) their development in the long run.On the other hand,in many cases parents' decisions are not toronto asian escorts (http://www.escortstorontodirectory.com) always in accordance with children' personal ideas and interests,this will toronto escorts (http://www.escortstorontodirectory.com) make children form resistence and naturely influence their growth.

jasonrkba
05-29-2010, 11:01 AM
Any suggestions? Maybe I can file the track down so I can use the new style.

bfisher
05-29-2010, 02:40 PM
The problem you are having is usually indicative of a peep sight that is too high, which causes you to anchor very low. This is also often caused by the draw length being too long on the bow.

Frankly I wouldn't be able to tell about the draw length without some pictures of you at full draw, but you sure wouldn't be the first with this problem.

If you can lower the peep maybe 1/2" or so it would make it necessary to lower the sight pins also. This is what I'd try if it were me. It wouldn't change your anchor so drastically that you can't adapt and it just might be enough.

jasonrkba
05-29-2010, 04:44 PM
That makes great since, I'll give it a try. Thanks!