Leopard cam lean

[Metal Mick]

Hi all,

my wife's 2009 Leopard has a bit of cam lean, and it is so bad that the serving on the cable is abrading.

Can anyone propose a solution? The bow is practically brand-new. I bought it for her and she hardly shot it, but has recently picked it up again.

I really don't want to re-serve the cable every few weeks.

Cheers,

Michael P

[Destroyer]

Warranty claim if you can. The cable is wearing where exactly? :)

[Metal Mick]

Hi,

when drawing the bow, the cable does not engage the track cleanly and about an inch before the junction of the cam and the module, the cable is almost half off the track. As the draw stroke progresses, the cable snaps into the track, and it is at this point there is wear on the serving.

The bow is at maximum draw length (26"). Poundage is right down to minimum. ATA and brace height are as per specifications.

If lodging a warranty claim, what exactly is the part I am claiming is faulty? Is it the limb?

Cheers,

Michael P

[Destroyer]

If lodging a warranty claim, what exactly is the part I am claiming is faulty? Is it the limb?

Alignment is bad. I would say exactly what you have just said, the cable is wearing and where its wearing. :)