PDA

View Full Version : Nitrous conversion



hotrod26
01-07-2011, 01:41 PM
I have a question for all the Slayer/nitrous cam gurus on here. I have a 08 Slayer with the Cat cams and 13" limbs which one of the limbs is cracked. Would it be possible to take a set of 14" limbs from a 06 Slayer and Nitrous B cams install them on the 08 riser and still have the same ATA as the 06 Slayer w/B cams? I hope I have explained what I want to do. If that would work I would be able to use the string and cable measurements for the 06 Slayer with B cams. I like the feel of the 08 riser and the reduced weight over the 06.

copterdoc
01-07-2011, 05:52 PM
Are you sure you have an 06 Slayer?

As far as I know, the riser didn't change at all, from 2006 through 2008.

hotrod26
01-07-2011, 06:35 PM
Yes it is a 06.The length of the risers are the same. The difference is that the 08 has some material removed to reduce the overall weight.

wisecane
01-10-2011, 04:32 AM
Grip angle was changed at some point. If you have a Slayr (older bow) it will have a different grip angle than a Slayer. I have both. Scepterman30X can verify the actual angles.

scepterman30x
01-10-2011, 05:47 AM
Grip angle was changed at some point. If you have a Slayr (older bow) it will have a different grip angle than a Slayer. I have both. Scepterman30X can verify the actual angles.

23 degrees vs. 17 degrees