PDA

View Full Version : rytera nemesis let off



Unregistered
01-24-2011, 01:24 PM
So I dont know too much about adjusting the let off on my nemesis, If I draw the bow fully then adjust the stop(at full draw) to just touch the bottom limb, I am at 80 % let off.
So too lower the let off, say to 65 %, I would adjust the draw stop so it contacts the limb sooner, correct? But could you not pull it hard enough against the stop(on the bottom limb)to keep rotating the top cam while the bottom is not moving, changing cam timing?? Also would this effect draw length?

Spiker
01-24-2011, 02:37 PM
Well yes and yes. To a degree...
BUT. If your pulling the bow past the draw stop I would think that you have a longer draw than what the bow is set at.
Set the draw stop to your draw length.
If you want less let-off then set the module to the next longer setting.
If you have a 47" draw length and have the bow set to stop at 47" why would you try to pull it past that?

machinegunjohn
01-25-2011, 07:11 AM
So you use the draw stop to set draw length and the draw length modules to set let off?
So if this is how it works, where do I initialy set my modules to, I am 29" DL. Do I set them to the 29" holes, then set my stop to touch the limb at full draw,(this would be 29" @ 80% let off??) then adjust modules, leaving the stop alone, to achieve desired let off?
Thanks for the help?

elkslayer4x5
01-25-2011, 10:03 AM
If you have a 47" draw length and have the bow set to stop at 47" why would you try to pull it past that?

:eek: why indeed! :D Is any bow capable of being draw that far? Hard enought to find a bow with that sort of A2A length. :)

archerx7
01-25-2011, 03:46 PM
Set the mods on the 29" setting and set the DS to stop the cables just as they get to the end of the flat part of the track on the mods, this will give you the 80% letoff and a 29" DL. Actually if the string and cables are set to spec you will have about a 29.25 measured AMO DL with the mods and stop set here.
To get a 65% letoff, you will need to use a scale to measure the holding weight at full draw each time you shorten the DS.

Hutch~n~Son Archery
01-25-2011, 04:07 PM
I agree archerx7. I did mine just the way you mentioned. I put it in my drawing machine and it made it much easier to adjust the draw stop. But once adjusted it was the best fitting draw length I have ever had.

Hutch