Arrow spine help
So i've had my Saber takedown bow for a couple of weeks now and am so far loving it. Today i decided to have a go at tuning the bow to get the arrow flying perfectly so i stripped the plastic fletchings of one of my cheap 30" armex arrows and had a go at bare shafting. I bought these arrows before i knew you had to buy specific arrows for certin bows and poundages.
Anyway, i think the spine is to heavy for my bow so i want to buy the correct arrows for my bow. Has anybody got any suggestions for what arrow to use? My Saber is 40# but i'm not sure what weight i'm pulling in at. Probably around 28". I've had a go at Eastons spine calculator but i was confused about the point weight?
Any help would be great.
Hey TP, try this! I am sure some others will pipe in.
The bow's draw weight is calculated at a 28" draw so if you're actually drawing 28" then it's 40# or close to it. Add or subtract 2# for each inch difference that you are drawing from 28". 2# less for 27". 2# more for 29".
If using a carbon arrow with a 100 gr point the Easton chart calls for a 500 spine.
Thanks for that link Hutch, that there is an in depth calculator! Unfortunatly though, the Saber is not listed though.
Originally Posted by Hutch~n~Son Archery
Thanks for the reply bfisher, i will have to try and get an accurate measure on my draw tommorrow.
Originally Posted by bfisher
Yeah, but the gr of the point is where i am getting the most confusion. What does a higher or lower gr point indicate? And what gr would be a good start? I'm only shooting targets.