Search:

Type: Posts; User: wegel11

Search: Search took 0.06 seconds.

  1. Replies
    8
    Views
    797

    I don't think they are too tight, but I can take...

    I don't think they are too tight, but I can take a closer look. Sonny, thanks for the suggestions, I will give that a try and see what happens.
  2. Replies
    8
    Views
    797

    Sorry for the confusion, when I said tiller even,...

    Sorry for the confusion, when I said tiller even, all I did was make sure the limb bolts were backed out even and verified by measuring between the limb pockets and a string attached between both...
  3. Replies
    8
    Views
    797

    Just rechecked everything, cams perfectly in...

    Just rechecked everything, cams perfectly in sync, tiller even. ATA=31.5 BH= 6 7/8 Peak draw weight 72lbs

    I guess I will have to tune the rest with broad heads and call it good. My OCD...
  4. Replies
    8
    Views
    797

    Hybrix cam tuning

    I am trying to dial in my 2010 Alien X. I have set my tiller exactly even and the cams seem to be perfectly in sync using a draw board. When I set my rest through the center of the berger and the...
  5. Replies
    1
    Views
    711

    Cable rod conversion- cable length

    I recently converted my 2010 AX to a cable rod/slide. I read that in order to regain peak draw weight the cables need to be 1/2 inch shorter than factory specs. So, I ordered a set of new...
  6. Replies
    5
    Views
    589

    I may have found the root of the cam lean issue....

    I may have found the root of the cam lean issue. I stripped the bow down and noticed that the pin used to align the top rotocup was sticking out too far and rubbing on the groove. It looks like this...
  7. Replies
    5
    Views
    589

    I'm 99% sure it has the newer style flange...

    I'm 99% sure it has the newer style flange bearings. There are no plastic washers, and the far outside of the bearing is a silver metal. (reading other posts described the 2010 bearings like this)
  8. Replies
    5
    Views
    589

    2010 Alien X- loose cams?

    So I am wondering if it is normal to have lateral movement in the cams on a 2010 alien x. I have had some cam lean for a while now and recently decided to swap the top and bottom limbs (css is...
  9. So use the string lengths as a starting point,...

    So use the string lengths as a starting point, then make adjustments to bring the BH and ATA within 1/8th of the specs? Now I need a scale to test the final draw weight.
  10. alien x string length vs ATA and brace height

    So whats more important, setting the strings to exact spec or adjusting them so that ATA and BH are closer to spec? With my alien when I set the strings to spec the ATA is 31 1/4 so its a little...
  11. Replies
    2
    Views
    645

    Thanks I will give those a try

    Thanks I will give those a try
  12. Replies
    2
    Views
    645

    Rytera Alien X Draw stop hex size

    Just got a 2010 Alien X and was setting up the draw length. I cant seem to find a hex wrench to loosen the draw stop. I was wondering if anyone could tell me what size it is. Cant wait to get it set...
Results 1 to 12 of 12