Martin Onza III Question....

[peace]

The Martin Onza III lists its longest draw length @ 30.5". Does anyone know if this is a long 30.5" or a dead nuts 30.5" and hopefully not a short 30.5"?

[wscywabbit]

Well, that's an interesting question... Before I bought my Onza, I emailed Martin to see if their listed specs were AMO draw or tru draw, and they said that all their specs are AMO. That being said, the shortest draw (per spec) should be 27.5" AMO. My AMO draw is 28.25", and I am on the shortest setting. So 3/4" off. So it would go with out saying that all things being equal, it should make the 30.5" max draw would then be 31.25... Hope that helps. Maybe if anyone else has had a similar experience with the bow they could chime in too...

[peace]

That is exactly the info I am looking for as I wanted to know if my 30.75" draw could find itself in the Onza III. Thanks.

[peace]

1/2-3/4 over I can deal with which is what I was hoping for. That means this is another possible for a new bow.

[wscywabbit]

Had my hands on just one. Held to listed ata, 33 1/4", it checked exactly 26 1/4 and add the amo 1 3/4" gave it a honest 28.0" draw with the mods set to 27 1/2". So figure plus 1/2". Even if exact a little string tweaking would give you your draw length. Twist cables and untwist bow to lengthen. Just maintain ata and all will be well.

sounds about right. I did get mine down to the same, but it dropped the weight to under 70, and I didn't want to play with the cables anymore, so I put it back. I wasn't worried about the 1/4" lol.

[wscywabbit]

I've played with draw lengths on two Shadowcats, two Nemesis, one Alien X and one Onza 3. Not one of them gained or lost poundage. One Shadowcat had strings twisted and untwisted to extremes, right to the point the cams looked totally wrong, but draw length was exact to the mod setting. There was no loss of draw weight.

Huh, the bows I've played with if the shooting string was long, the poundage went up. If I short-strung them, the poundage went down. When I was setting up the Onza (first dual cam I've played with) it came with the ATA at 33 3/4, and the BH was 7", and the DL was long. As I cranked the cables down to bring the ATA down, DL and BH increased (slightly), and the poundage went up. Shortened the string to bring DL down to spec, and the poundage went down. It ended up being a balancing act! At the end, my ATA, BH, and poundage were dead on, and the DL was a little long...

[Sharxfan]

So peace where are you thinking about buying the Onza from?

[rdhj]

Well, that's an interesting question... Before I bought my Onza, I emailed Martin to see if their listed specs were AMO draw or tru draw, and they said that all their specs are AMO. That being said, the shortest draw (per spec) should be 27.5" AMO. My AMO draw is 28.25", and I am on the shortest setting. So 3/4" off. So it would go with out saying that all things being equal, it should make the 30.5" max draw would then be 31.25... Hope that helps. Maybe if anyone else has had a similar experience with the bow they could chime in too...

dang the the answer i was looking for....have mine set on the shortest setting and it measures at 28 1/4" also....