Results 1 to 3 of 3

Thread: question on saber se cable slide

  1. 04-09-2007, 10:38 AM #1
    MRHAPPY Guest

    Default question on saber se cable slide

    repeat,how do i delete?
    Last edited by MRHAPPY; 04-11-2007 at 11:44 PM.
    Reply With Quote Reply With Quote
  2. 04-11-2007, 11:48 PM #2
    MRHAPPY Guest

    Default

    got the cables to stop rubbing, but still have some idler wheel lean, how much is too much? have cable rod in as far as i can go without touching fletching, how can you really tell what amount of lean is a problem?
    Reply With Quote Reply With Quote
  3. 04-12-2007, 09:02 PM #3
    bfisher's Avatar
    bfisher
    bfisher is offline Administrator
    Join Date
    Nov 2005
    Location
    Middletown, Pa, USA
    Posts
    10,742

    Default

    I don't like any lean at all. Do you know how to check for lean? Hold an arrow along the side of the idler wheel and it should parallel the string. Depending on which way it's leaning you have to twist up one side of the yoke of the cable where it attaches to the top limb. It's a bit of trial and error till you get it right.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules