I recently bought a Martin Cougar SE and its been shooting great.
Unfortunately i noticed soon after purchase that a segment of serving on one of the bus cables was continuously getting sliced, it appears to happen everytime the bow is drawn, the bus cable rubs against a sharp side of the circular pulley in the top cam.
Any ideas on how to stop this? The opposite side of the small pulley that is causing the abrasion is smooth, could it be on backwards?
I don't quite get what you are describing. What cam are you shooting? If you are shooting a Dynacam or MPro then I think your idler wheel might be leaning quite a bit. To remedy this you need to twist up one side of the cable yoke so the string is coming straight off the wheel.
If you are shooting the Nitrous cam then the same procedure applies.
It's best to sue a bow press for this, but if you don't have access to one then you can just back off the limb bolts (evenly) till the rigging goes slack.
I think it is the Dyna Cam, ill post screen shots tonight. I'll try that yoke twist technique as well to see if that can improve things. I think you're dead right about the idler wheel. Thanks.
The reason I say idler wheel is because you said "top limb". Although this may be the case it would have to be pretty severe "cam lean". I don't think I've ever seen an idler leaning enough to slice the serving, but you might have it none the less.
I have an 07 bengal with m-pro cam and it's slicing the serving where the draw mod meets the cam, hasn't got the string yet. When I bought the bow it did not have a cable guard, so I got one and set it up and think I had a little too much clearing for the fletching. Making the cam lean to drastic.