Arrow vanes hitting cable?

[Buzz Lite Beer]

I would still turn the slide rod out but have it angled at 120° that way you are bringing the slide further down pulling the cables out of the way but nearer the arrow (optimising clearance but with minimal torque)
1, Rotate nock
2, Refletch, get lower profile vanes or even try feather fletchings

[Arrow Splitter]

Having looked at thoses photos.

1: Has the cable slide been correctly installed? If it was flipped over 180 degrees on the rod the shorter end would be at the back.
2: I have also tried to view other setups to get closeups of cable slides so I cannot be 100% with the above observation, or if the slider block should be position to the outer side of the rod & not on the rest side.
3: Smaller vanes can be fitted.

The cable rod appears to be installed correctly. The cable slide only works the way it's installed, on the arrow rest side.

A.S

[Speedykills]

Go to your proshop or online and get a tighter cable slide,there are different ones to choose from.


http://www.keystonecountrystore.com/..._-_Guards.html

[Arrow Splitter]

ajinid, you probably should give Martin a call and see what they think. They should be able to take care of your problem.

A.S

[MLN1963]

Go to your proshop or online and get a tighter cable slide,there are different ones to choose from.http://www.keystonecountrystore.com/..._-_Guards.html

Speedy
Do you have any suggestions?

[Speedykills]

Speedy
Do you have any suggestions?

Yes that is what the link i provided is for.

[MLN1963]

I didn't see any measurements given, did I miss something? I was asking if you had any suggestions as to which ones would get the cables closest to the cable rod based on any experience you have with them.

[Hutch~n~Son Archery]

Got a 2011 Saber for Christmas. Noticed that the one of the cables appears to be in the path of the blazer vanes on my arrow. Can't tell if this is really affecting my shot cause I'm just starting to sight in my bow. I tried playing w/ the cable guard and slide but can't get the cable out of the way enough. Is this something I should worry about?

Welcome to the forum, My suggestion is to call Martin and tell them what is going on. The bow should not have that problem. I am sure they can get you pointed in the right direction. I looked at a lot of videos on the Saber and none had that problem.


Hutch

[Speedykills]

I didn't see any measurements given, did I miss something? I was asking if you had any suggestions as to which ones would get the cables closest to the cable rod based on any experience you have with them.

Ok if martin cant help i would rotate the rod to 1 oclock position and use this cable slide......http://www.keystonecountrystore.com/...GS1940403.html


On the ross bow i had recently it had a cable slide that was like the OP,stuck out quite a bit,also reminds me of the ones hoyt has on there bows ,but if i didnt sell it i was going to get this one in the link.