Hammer Head Bow Strings

[Hutch~n~Son Archery]

That being said, Hey Hutch, do you have Trophy in Mountain Berry. I think I want Mt. Berry for my new Crimson Red Nemisis. I gotta figur out the other color to go with it. How about clear halo serving material.

Sure do have mt berry and clear halo. I believe this is mt berry and silver if it isn't pretend it is. Lol




Hutch

[bigredhunter00]

As said to another post GO HUTCH OR GO HOME!

[droppixel]

I want to throw something in here. The Hammerhead strings may be mass produced, but are a darn fine string considering that. From what I've seen they have gotten better since last year. For you guys talking about premature serving wear? In most cases this is not a product of poor serving or the serving material. It's because of sharp edges on the cams and/or poor cam alignment (can lean) or module design. Martin would be doing themselves and their consumers a huge favor to change the machining of the cams and modules and put a radius on all the edges like the Nitrous cams had. I haven't had any issues with serving separation so can't say one way or the other on that. Let's just say that Martin strings are far and away better than what comes on most production bows.

That being said, Hey Hutch, do you have Trophy in Mountain Berry. I think I want Mt. Berry for my new Crimson Red Nemisis. I gotta figur out the other color to go with it. How about clear halo serving material.

Two very good points. Like Hutch mentioned if these are done by machine, I noticed a goofy spot where my yoke is served. I'd have to get a picture of it, but the 2 colors have a funny separation in them, not major really. I noticed on my module there was a little bit of a lip, just smoothed it out, no problem. One thing I'm going to keep an eye on with mine is the tick for the 1 goes all the way to the edge, just keeping an eye that it doesn't create an sharp edge itself. Strings are strings and one way or another they are going to need to be replaced so really when you look at the big picture it's no big deal.

[MartinMan]

As said to another post GO HUTCH OR GO HOME!

I have a set of his strings on a bow that I gave to my father for christmas. It is by far the best set I have had to date.

[justin]

Would this az look good with black and red strings i wonder?

[droppixel]

Just my opinion, Aliens must always have some green

I have seen some black and red on guys bows and it looks pretty sweet if you can get a few other things to highlight it with.

[deadeyeshot]

Hey there! been shooting my pantera magnum this morning and when i was going to store it i noticed the rubber X thing(string suppresor maybe?) on the bottom came off. I found it and it has been chopped in half presumably by my string. Should I be alarmed?

[Thermodude]

Hey there! been shooting my pantera magnum this morning and when i was going to store it i noticed the rubber X thing(string suppresor maybe?) on the bottom came off. I found it and it has been chopped in half presumably by my string. Should I be alarmed?

Hello!..................I wouldnt be concerned about that , it happens. Its easy to be replaced by backing out your limb bolts to relaxe the cables or by putting it in a press.

[bfisher]

If yors has been cut in half then it probably isn't going to be of much use. If you have an archery shop anywhere nearby you can get a replacement. Simms makes a good one and it's of softer rubber. It should slide right on without having to back off the limb bolts. Just pull the string to one side and slip it on the end of the rod. However if your rubber stopper is too close to the string it should be adjusted so that there is about 1/16" between the string and the bumper. There are two setscrews in the riser to loosen to make the adjustment.