Martin Cat cam 2008 and 2010

[Dado]

Hi guys,
I have a shadowcat 2010 that was half-dryfired (cat 1.5 cam) and the bottom cam got slightly bent.
I have been trying to find someone with a pair of those cams on AT to buy,
or to try to contact someone from Martin to see if these could be available to purchase.

So far no luck.
I got only one guy offering me the 2008 Cat cam, but neither him nor me know if the 2008 cat cam and 2010 cat 1.5 are the same?

Does anyone know anything about this?

Also, I have tried to contact martinarchery tech support, but no reply (must have been more than 10 days now).


In any case, I have got a pair of spare limbs for the shadowcat, it is still shootable with the bent cam, however, I'd like it to be as better as possible, so I want to replace the bent cam... How can I get help on this?
Thanks

[Ehunter]

I have a 2008 and a 2010 bow that both have the Cat cams. I can't see any difference between them. Mine are the regular Cat's, not the 1.5's. There will be a difference between the Cat's and the Cat 1.5. The 1.5 was for a shorter draw length.

[Dado]

I have a 2008 and a 2010 bow that both have the Cat cams. I can't see any difference between them. Mine are the regular Cat's, not the 1.5's. There will be a difference between the Cat's and the Cat 1.5. The 1.5 was for a shorter draw length.

Ok then, how do I get in touch with Joel C?
I was told he could help me out...

[Sonny Thomas]

Trying to remember...You're from??? I asked you to check here, I think. Link below should get Joel..

http://martinarchery.com/mtechforum/....php?122-joelc

[Dado]

Trying to remember...You're from??? I asked you to check here, I think. Link below should get Joel..

http://martinarchery.com/mtechforum/....php?122-joelc

Sonny, yes, I posted on AT as well...
Joel's page does not have any contact info... I can't even PM him...

[Arrow Splitter]

Ok then, how do I get in touch with Joel C?
I was told he could help me out...

Call 1-509-529-2554 and press 3 for Tech Support, or email joel@martinarchery.com. You can't get in touch with him through this forum.

By the way, welcome to the Martin Tech Forum.

A.S

[Dado]

He replied to my email and is sending me the replacement cams.
Thanks Joel and Martin