Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12

Thread: Removing cam bearings

  1. #11
    Senior Member wscywabbit's Avatar
    Join Date
    Nov 2008
    Sultan, WA
    Post Thanks / Like


    thanks for the info Frankensteel, and welcome!
    In God and guns we trust;
    • One nation, under God, indivisible, with liberty and justice for all.
    • A well regulated Militia, being necessary to the security of a free State, the right of the people to keep and bear Arms, shall not be infringed.

    2011 Onza 3: 70#, 28.25 draw (AMO), 384 gr arrow, 288 fps
    2005 Saber: 70#, same arrow, 250 fps

  2. #12
    String builder/ Super Moderator Hutch~n~Son Archery's Avatar
    Join Date
    Aug 2009
    Gilmanton, New Hampshire
    Post Thanks / Like


    Quote Originally Posted by frankensteel View Post
    Flanged, double sealed,grease lubricated, ABEC 1 chrome steel- available from Grainger, Dayton#1ZGE5, also generic part# FR3-2RS. About $8 each. You can find them on the internet cheaper- about $4 each from Not sure if the quality is the same. I will find out, because I installed two from Grainger and two from!
    This is a sealed bearing- rubber seal, as opposed to a shielded bearing, which has a metal shield, which can be lubricated, but will not keep out water or dirt. Use the sealed units.
    I just installed them in my '09 Rytera, which came originally with non flanged bearings. These look like they will offer more support since the flanged section extends out over the axles.
    I think these are the same bearings in the Martin cams- check the dimensions above.
    Hey- this is my first post!
    Hello all.
    Welcome to the forum and great info!

    Bow String Depot Custom String Builders
    Need a string set pm or email me @
    or check us out @

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts