I am trying to dial in my 2010 Alien X. I have set my tiller exactly even and the cams seem to be perfectly in sync using a draw board. When I set my rest through the center of the berger and the nock point at 90 degrees the bow will paper tune with about 3/4 inch nock low paper tear. I can raise the nock point to get a good paper tune, but still think that the bow should tune with a square nock point. Should I try letting the top cam start rotating on release earlier than the bottom by maybe 1/2 twist? Specs listed below:

2010 Alien X hybrix cam- with cable rod conversion
28'' draw
70lbs

28'' cabelas stalker extreme arrows
100gn point
25gn additional insert weight
2'' fusion vanes
5gn QAD tune-a-nock's