Results 1 to 4 of 4

Thread: another pantera?

  1. #1
    Junior Member
    Join Date
    Jun 2013
    Posts
    11
    Post Thanks / Like

    Default another pantera?

    ok, so i backed the limb bolts out about 14 turns so i could move the cable to the -10 post now this is probably a stupid ? but after i got everything tightened back down it looks like the cam is partially rotated, is this normal? also im having a tough time getting the draw stop set where it needs to be and its wearing my serving just by drawing it back...thanks in advance

  2. #2
    Member
    Join Date
    Aug 2011
    Posts
    71
    Post Thanks / Like

    Default

    Yes, the cam will be rotated by changing the cable position on the cam, that is how you get the adjustment range.

    Try to adjust the draw stop so the cam stops rotating just and the point where the cable begins to contact the axle, that should help reduce the wear on the serving. If you have a draw board, or someone else to watch as you draw the bow back, that is helpful.

    Good Luck!
    Last edited by DeanRM; 07-10-2013 at 09:11 AM.

  3. #3
    Senior Member wscywabbit's Avatar
    Join Date
    Nov 2008
    Location
    Sultan, WA
    Posts
    1,525
    Post Thanks / Like

    Default

    If you can't get your draw stop setting short enough to keep from over-rotating the cam into the cable, then your draw length mod is set too long. You should change the mod setting and then set your draw stop so that it stops at your draw length BEFORE it rolls past the cam axle. It may take some trial and error to get it correctly set...
    In God and guns we trust;
    • One nation, under God, indivisible, with liberty and justice for all.
    • A well regulated Militia, being necessary to the security of a free State, the right of the people to keep and bear Arms, shall not be infringed.


    2011 Onza 3: 70#, 28.25 draw (AMO), 384 gr arrow, 288 fps
    2005 Saber: 70#, same arrow, 250 fps

  4. #4
    Senior Member typically8's Avatar
    Join Date
    Apr 2012
    Location
    Central Texas
    Posts
    576
    Post Thanks / Like

    Default

    Here is what Joel said to me before his departure. Basically lengthen the draw and shorten the stop so you don't hit the axle w/ the string. Also, check the pegs and module for any burrs, they might need a light sanding.
    2013 PANTERA w/ cloaked cams, PINK Meta peep, PINK/BROWN BSD strings, PINK/BROWN BowJax, Truglo Range Rover Pendulum Site, Shockwave Stabilizer
    2012 Onza III w/cloaked cams, Meta peep, Truglo Micro Brite, Shockwave Stabilizer
    2010 G5 Quest Primal
    True-Fire Hardcore and Winn Free Flight releases
    Maxima's tipped w/ RAGE broadheads (some w/ PINK fletching)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •