Slayer SE Question
I just got a Slayer SE and I had a couple of questions about it. I was wondering why it feels like there is no let off when it is at full draw and why there is no break point when it is at full draw. It has the Nitrous Cam system. If anyone could help it would be great thank you.
Sounds like your timing is off.
It doesn't have much of a valley but it does have one and it does break over and they do have the right amount of let off.
But when your timing is off it feels like you describe.
It will also feel that way if the draw length is too long for you! When the top and bottom cams roll over, do the "stops" that touch the string "touch" at the exact same time? This is the timing that MYK is speaking of.
Pull the string back slowly, and look, or have someone else watch, to see if the stops contact the string at the same time.
I checked the timing and it looks like the timing is on and I have the draw length set to my draw length.
What cam size, I am assuming "C", and what is your draw length? If your drawlength is set on the short side of the cam, your letoff will be affected. These cams need to have full rotation to get the best possible letoff.
I am dealing with the same thing on my Rytera BulletX. It is set @ 29.5", with the max being 30". It gets the full rotation and the cams are in time. However, I am drawing 71lbs and holding 27lbs. That equates to 61.9% letoff and it has the HL modules, not the 65%. I know, I have both. I even compared the modules to verify my set was not 65% and accidentially marked HL. They are in fact HL.
Heavy cables and serving will effect your let-off too. Very much so if they're so heavy they won't settle all the way into the groove.