2010 Firecat out of spec

[sapper1]

I measured my new Firecat and found that the A to A is about 32 3/4" and the brace height is 6 3/4". Should I worry about getting it to spec and if so what is the best way to do it?

[Brem]

Sapper1,
You need to put several twists in both cables to get the brace height right. Check your poundage once you get to 7". if its over max you will need to also twist your string up. This will increase your draw length so you may have to mover your module and stop to compensate. Do not try and get to the 32 1/4 ATA spec, per martin the TR2 is closer to 32 1/2 than 32 1/4.