Setting draw length on shadowcat

[CarlosII]

I need to adjust the modules on the 2010 Shadowcat. I cannot find any reference marks on the modules that would indicate the draw length. My bowtechs have numbers that correspond to the draw length setting but I can find no such marks on the Martin.

Help please!

[Montalaar]

You modules should have numbers ranging from 1 to 7. 1 is the shortest possible setting, 7 the longest.

[Montalaar]

Oh, you found my answer not helpful.. Well.. me neither....

Look at this. Here you can see where #1 and #7 are.

http://www.martinarchery.com/manuals...e_settings.pdf

[CarlosII]

Sorry I didn't respond immediately but I was out of town.

I can't find any numbers on the modules. Is it possible that the previous owner could have switched the top module with the bottom module some way?

Confusing.

[SonnyThomas]

Sorry I didn't respond immediately but I was out of town.
I can't find any numbers on the modules. Is it possible that the previous owner could have switched the top module with the bottom module some way?
Confusing.

Carlosii, I don't see how. My mods have a ridge on the side showing and flat for the side against the cam. If in doubt pull the 2 screws and check.
I suspose the previous owner could have scrubbed the numbers off, but dang... My mods are numbered in bright white.

[CarlosII]

Sonny,
I thought they should have some highlight of some kind but not on this one. I took it up to Girts and the tech there, who also shoots a Shadowcat was dumbfounded to not to be able to find any marks on it.

I think I'll give a call to Martin and see what they can tell me. I would think any draw mods from any manufacturer should have such marks. Can't imagine he made his own mods...but cha never know, right?

dang its cold out there this morning...to heck with muzzleloader season...i'm stayin' inside.

[SonnyThomas]

Yes, cold here to. I thought about going out bow hunting. 14 degrees had me roll over and go back to sleep. Might go out this afternoon. Suppose to get up to a blazing 25 degrees.

[Spiker]

Take a white Sharpie and mark your modules...
This is the bottom cam set on #4.

[NeilM]

I think you can pretty much work it out from Spikers photo. 1 is the shortest draw and 7 the longest (that's me). Just make sure you have both modules set to the same hole.

Very strange that yours have no marking though.

[Spiker]

I think on the '10 Shadowcat it's:
1= 27"
2= 27.5"
3= 28"
4= 28.5"
5= 29"
6= 29.5"
7= 30"