I want to get my cams and sight film dipped. I thought that I'd leave the modules on the cams and just have them dipped as a single piece. The sight is another story, as I see it I need to break it down to 3 pieces. There's a slight problem, as I want the inside of the pin housing to remain the flat black it is now. If I move the rheostat up over the fiber that should protect the fiber from being dipped, but how do I keep the film from entering the housing ? The 06 Slayer is Mossy Oak Break up, but Mossy Oak isn't avaible as a dip film. Of the 14 samples below , which would you choose?