Just got my new Onza Saturday, and have been getting it set up. The cam timing was way off, so I started twisting up the cables. For some reason, I can't get the bottom cam to advance with the top cam. Top cam is hitting flat well before the bottom. I put a twist or two in the bottom cable that feeds into the top cam, and get close, then add one more, and it gets further off again. Would it be the same thing if I took a twist OUT of the cable feeding into the bottom cam, as it is twisting INTO the top cam? Wondering if this might make the difference I need. ATA is 33 3/4, BH 7 3/8 It's just not making sense acting the way it is.