So whats more important, setting the strings to exact spec or adjusting them so that ATA and BH are closer to spec? With my alien when I set the strings to spec the ATA is 31 1/4 so its a little short, and the brace height is 6 7/8 which is on par with most. When I measure the draw length its about 3/8 inch longer than the setting on the mod. So should I leave it as is with the strings to spec, or adjust it so the ATA is closer to 31.5? In the past when I had it at exactly 31.5 the BH was 6 3/4 which is shorter than most AX. I dont have a scale so I cant tell you what the DW is at the current setting. My OCD is not allowing me to leave it alone.